घरेलू पम्प » Horizontal Openwell Submersible Pumps - CSS Series

Openwell Submersible Pumps Manufacturers

These centrifugal pumpsets are ideally suitable for openwells or tanks where there is a wide fluctuation in water level occur. This works under water and it rests at bottom of the well. Hence suction and priming problem do not arise. Pump’s volute chamber is designed to give the best possible hydraulic efficiency. Dynamically balanced impeller offers vibration free operation with long life. Prime mover is rewindable, water - cooled motor. Specially designed water lubricated bearings are used to withstand axial thrust loads with minimum wear and tear. The stator is wound with special water proof synthetic film insulated copper winding wires and made up of low watt loss steel laminations assembled under pressure and rigidly locked in stainless steel stator shell.

Dynamically balanced Rotor gives vibration free and noise free operation, thereby increases efficiency and life cycle of the motor. Motor sealing is made by means of grommets, ‘O’ rings, oil seals and sand guard to avoid ingress of well water / sand into the motor. Pressure equalising rubber diaphragm is provided to guard the pressure and volume variation of water inside motor.  Motor must be filled with clear, cold, drinking water as detailed in our operator’s manual. Three phase motor requires an adequate motor protection control panel.
Power Range 0.37 kW – 1.5 kW (0.5HP-2.0 HP) Horizontal
Speed 2880 RPM
Version Single phase 220-240V, Three phase, 380 -415V, 50Hz, A.C Supply
Maximum total head Upto 44 mtrs
Maximum flow rate Upto 195 m3 / h (54lps)
Degree of Protection IP 58
Direction of Rotation Clockwise viewed from driving end
Normal delivery size in mm 25, 50, 65, 80 & 100
Type of Duty S1 (continuous)
Method of starting Capacitor Start Capacitor Run (CSCR) / Permenant Split Capacitor (CSR) Direct on Line upto 5.5 kW, SD upto 37kW
Maximum starts per hour 6 times
  • SS and carbon thrust bearings used in vertical openwell sub
  • Bronze impeller in specific models
  • Specially designed journal bushes for better cooling effect
  • Intended for wide voltage fluctuations
  • High operating efficiency
  • Detachable pump and motor in vertical higher stage pump
Material of Construction
Part Name Material
Rear Cover / Bracket Cost iron
Stator Shell Cost iron / S.S / M.S
Shaft SS AISI 410
Impeller Cost iron (FG 200 / S.S AISI - 304 / Lead Bronze
Pump casting Cost iron(FG 200)
Shaft seal Nitrile butyl rubber
Thrust Assembly Leaded Bronze and Compostos / SS 420 with Graphite Carbon
Diaphragm High Nitrile butyl rubber
Journal bearings LTB 4
 
Back to Home Pumps